It has 4 inputs (labeled 1-4) and 2 ouputs for sound(labeled Left/Right). Input should except both audio and CV but are intended for audio

use. Input 1 and 3 are connected to left out whereas 2 and 4 are hooked up to the right output.

It has a clock input and an audio (clock)input, you can use both at the same time if you want to.

It has a gate out that keeps track of what is going on within the circuit, but since pauses are a

thing in this design this is reflected here as well, so don’t expect a steady clock for the most

part. The top switch sets how many active steps each sequence will have, 4,5 or 8. When

selecting 5 or 8 the circuit will insert pauses where there is no input (abover step 4 that is).

The bottom switch is for division of the audio clock, if you want it to go somewhat slower or

faster. Sometimes this circuit locks up, if so you can switch the division switch and see if it

comes alive again. There is also a button for manual stepping and setting the “start” position

for a sequence before adding a clock. Ie if you want the sequence to start at step 3 press the

button until the LED beneath panel for LED 3 is lit.