VPME.DE Zeroscope Partial Kit

Customer Reviews (3)

Awesome Visuals & Great For Module Calibrations!Review by Mr_Mojo_Risin'

I had this one in my rack for more than a year. It never worked properly after building it because a 'T?' error was showing at the bottom left of the screen. There was also a flat line for any readings less than 100ms. I resoldered R2, R4, D2 as suggested by some Wigglers with no results.

I finally got it working after cleaning all components with IPA to remove extremely small amounts of flux inbetween all components which are packed closely together (which is pretty much the entire board). I don't use extra flux for my builds but the flux core in the solder leaves very small traces which apparently causes short circuits sometimes. I had no idea. This certainly changes the way I will build from now on.

Even though this build uses 99% SMD components, I was able to solder everything by hand using a fine tip iron and had no issues (other than the flux problem (Posted on 5/20/2019)

Simple + Useful!Review by Dustin

Unbeatable price for this type of module! Build was pretty easy, but I would highly recommend that you read through the build guide and check out the board photos & schematic here: https://vpme.de/zeroscope/

Some of the part locations on the board are slightly ambiguous, so the reference helped a lot. (Posted on 9/10/2017)

Cheap, effective and easy to buildReview by Troy

I was after an oscilloscope for eye candy, and this fit the bill perfectly. An easy build, does the job, and doesn't cost a bomb for all the parts. Considering getting another one just so I can have more pretty lines going around. (Posted on 7/10/2017)