The Bipolar Attenuverter Chiclet was designed for the DIY modular fanatic.
It is now easy to install a true bipolar attenuator (ability to attenuate and flip the phase of any incoming signal) into any DIY project! Any modular format!
This chiclet is easily installed into your DIY synth project by mounting the pot to the panel just like your normal Attenuator would mount. Simply run power to it, wire your input and output pins and you're up and running! The chiclet comes pre-assembled, fully tested ready to go! Just power it and connect the I/O!
*The term kit is used lightly due to it not required any assembly other than wiring power and the I/O Pins.
Power: Runs off any +/-V power system (+/-12V +/-15V being the most popular)
|Additional Resources||See the pinout under the pictures - pretty straightforward!|