The Zlob Modular Attenumixer is a three channel passive attenuator with a sum. Each channel is normalled to the sum(VI) so it can be used as a 2 channel mixer and 1 channel attenuator, or a 3 channel mixer, or as 3 separate attenuators. Normalization to the sum is broken by inserting a jack into the outs of channels I-III. The Attenumixer works well with both cv and audio, although the potentiometers have a linear response. Since this module is passive there will be some amount of signal loss with the sum out.
Specs & Downloads
Specs & Downloads
|Additional Resources||Build Guide|
Customer Reviews (2)
- Works great, front panel too thickReview by Matt
- This module is exactly what I needed. Easy to make without a guide even for the inexperienced. My only issue is that the front panel is about twice as thick as all my other ones. This means that the screws included with my Make Noise skiff are not long enough to reach the sliding nuts and the screws included with the module are too thick to fit in the sliding nuts. (Posted on 1/22/2017)
- Relatively EasyReview by Jean-Pierre
Useful passive triple attenuator/mixer module. I'm new to this, and it took me an hour to complete. (Some of the pads are small-ish, so I took it slow.) Works really well.
Only thing I would note is that the screws provided for mounting to the rails were different. One was longer and had a flush head, the other shorter by about 2mm and had a tapered head. The latter doesn't work with my Happy Ending Kit so I'll have to go find a replacement before I can mount it. (The panel is acrylic and rather thick compared to the aluminum plate supplied with some other gear, which may be part of the issue, as well.)
Bottom line, good kit for any money, straight-forward for newbies. Screw length consistency would make this perfect. (Posted on 11/10/2016)