This module has its core based on the Korg FK-1 effects pedal, the rest of it has been re-designed to suit use in a modular synth. Early Korg VCFs consisted of high pass and low pass stages in series these were seen in the 700 and dv800/maxikorg (my all-time #1 factory synth). The FK-1 followed the same topology but used dual vactrols as the variable resistors.
I have only seen youtube demos of the FK-1 and read reviews on it, generally it was considered a bit weedy and thin. One thing I found was that it had ‘Brightness’ (Q) pots for each stage that actually did very little. I replaced these with fixed resistors and had just one overall Q path back to the input stage. This makes a big difference to the circuit and gets it all wet and squelchy.The choice of vactrols is of course very important for this module. The dual vactrols of the original have been replaced with 4 singles.
I have built three versions, one with Siliconex NSL-32s and two DIY vactrols with GL5516 LDRs, which have a very low dark resistance of 500kΩ. One of the DIY versions had the LDRs matched and the other didn’t. I like my sounds pretty rich and raw, for me the unmatched DIY vactrol version was best, maybe it was a fluke selection….the NSL-32 version the least favorite (but it still worked fine). So, you may want to experiment with different vactrols and matching to find a configuration that suits you. As I get feedback I will update this build guide or the relevant thread on Muffs. Basically it will work with any single vactrols but its character is very dependent upon which ones you choose. The original pedal had Hamamatsu P873 vactrols which had 1MΩ dark resistance (after 10 seconds) and 200Ω - 1kΩ on resistance.
Specs & Downloads
Specs & Downloads
|Additional Resources||Build Guide|