This sequential switch will do all your standard 1>2, 1>3, 1>4 or the other way around with great real-time as well as external voltage controllability.
But its when you start playing around with multiple sources and destinations that things start getting fun and weird! You could for instance shuffle around four different trigger patterns to trigger four different percussive generators for interesting variations, or why not 4 oscillators shuffling between 4 different destinations, panned and processed in various ways?
Whatever your sequential switch application might be, we're confident the Paths is up to the task!
Just like the VC Sequencer it is clockable by very high clock rates (100 kHz tested) and CVable with full audio range. All for your experimental waveshaping duties.
When clocking with FWD clock input or button the sequence will advance one step forward. When clocking with REV clock input or button the sequence will advance one step in reverse.
If a clock comes in exactly at the same time on both inputs the forward will have priority over the reverse.
In CV mode there is two CV inputs. The one that shares the reverse clock input is full wave rectified and the one that shares the forward clock input is half wave rectified. It uses an active rectifier without voltage drop or a dead zone around 0V.
The half wave rectified (FWD) with one bump on the rectifier symbol, will clip any signal below 0V and above 5V. The difference to the full wave rectified input (REV) with two bumps on the rectifier symbol, is that it will turn any negative volt into positive as well. So -1V is the same as +1V and -5V is the same as +5V etc.
- When I/O1 is connected to O/I1, I/O2 is connected to O/I2 and so on.
- When I/O1 is connected to O/I2, I/O2 is connected to O/I3 and so on, and I/O4 is connected to O/I1.
- When I/O1 is connected to O/I3, I/O2 is connected to O/I4 and I/O3 is connected to O/I1 and so on.
Specs & Downloads
Specs & Downloads
|Additional Resources||Build Guide|
Customer Reviews (1)
- Great module and great kitReview by Rodrigo
While it was a relatively complex build with tons of parts, the instructions were very very easy to follow. The order of assembly is really well considered, because height and other things will never get in the way.
Most components had extras, in case was lost of damage, which I didn't really need but it was nice to have a backup.
As a module, it does it what it says and it's great! I don't see it ever leaving my setup. I've also been using it at audio rate for very interesting results.
Physically it is pretty deep so it's not skiff friendly. And it has 3 pcbs and tons of parts. It took me around 6 hours of work to finish it. But I learned a lot about choosing the right order when assembling.
(Posted on 8/4/2016)